Effect of welding speed on Nd:YAG laser weldability of ZE41A-T5 magnesium sand castings

Download
  1. (PDF, 1 MB)
AuthorSearch for: ; Search for: ; Search for: ; Search for: ; Search for:
TypeArticle
Proceedings titleLight Metals 2005: 44the Annual Conference of Metallurgists of CIM, Calagary, AB, Canada
Conference44the Annual Conference of Metallurgists of CIM, Aug. 21-24, 2005, Calagary, AB, Canada
Pages137149
Subjectlaser welding; Nd:YAG laser; magnesium alloys; castings; weldability; welding speed
AbstractThe 2-mm butt joints of ZE41A-T5 sand castings were laser welded using 1.6 mm EZ33A-T5 tiller wire and a continuous wave Nd:YAG system at a power of 4 kW, surface defocusing and various welding speeds. Compared with the base metal, the fusion zone showed significant grain refinement due to high cooling rate. No grain coarsening was observed in the heat affected zone (HAZ). The porosity area percentage and total solidification crack length in the fusion zone (FZ) were reduced as the welding speed increased from 4 to 7 m/min. Fusion zone area, total penetration depth, and weld width decreased with increased welding speed. The hardness in the FZ was similar to or higher than the base metal after a natural aging of about one year, but there was a drop in the hardness of the HAZ. The HAZ width decreased with increasing the welding speed. Tensile test showed that a joint efficiency of approximately 75-90% was obtained.
Publication date
AffiliationNRC Institute for Aerospace Research; National Research Council Canada
Peer reviewedYes
NRC numberAMTC-2005-0057
NPARC number8930493
Export citationExport as RIS
Report a correctionReport a correction
Record identifier3c461655-2620-4a3d-9f3a-9ce1bf8f241c
Record created2009-04-23
Record modified2017-04-11
Bookmark and share
  • Share this page with Facebook (Opens in a new window)
  • Share this page with Twitter (Opens in a new window)
  • Share this page with Google+ (Opens in a new window)
  • Share this page with Delicious (Opens in a new window)