In situ measurements of wind pressures on low slope membrane roofs

  1. Get@NRC: In situ measurements of wind pressures on low slope membrane roofs (Opens in a new window)
DOIResolve DOI:
AuthorSearch for: ; Search for: ; Search for:
Journal titleJournal of Wind Engineering and Industrial Aerodynamics
SubjectMembrane roofs; In situ measurements; Wind pressure; NBCC; Roof zones; Pressure coefficients; Tributary area
AbstractPressure distributions created by wind flow on low slope roofs is an issue addressed by many wind tunnel studies and selective field experimental studies. Building codes and standards specify pressure coefficient data to determine the wind loads for commercial roofing claddings. Field measurements can provide valuable data to validate the current code provisions for wind loads, as well provide supporting data for existing wind uplift test methods for roof claddings. Thus the Special Interest Group on Dynamic Evaluation of Roofing Systems (SIGDERS) selected four locations (Ottawa, Vancouver, Mt. Pleasant and Rialto) across North America and collected wind speed, wind direction and wind pressure data for extended time periods to understand the wind interaction with low slope membrane roofs. This paper presents the data collected from November 2012 to November 2013 from the Ottawa, Ontario site. Based on the National Building Code of Canada׳s (NBCC) zoning procedure, pressure taps were installed to obtain data for the corner, edge and field roof zones. Occurrences of wind speed exceeding 16 m s⁻¹ were considered for various wind directions. Peak and mean pressure coefficients were calculated and compared with NBCC (2010)’s specifications. When instantaneous peak pressure coefficients were compared with the NBCC (2010), the measured data exceeded NBCC (2010)’s specifications for some wind directions. Nevertheless, when the pressure coefficients were compared by paring with their respective tributary area, the data concluded that the current NBCC (2010)’s specifications for the roof cladding and components are equally adequate for the wind load design of low slope membrane roofs.
Publication date
AffiliationConstruction; National Research Council Canada
Peer reviewedYes
NPARC number23000112
Export citationExport as RIS
Report a correctionReport a correction
Record identifier8d6b7a40-4ac3-4aa7-a7b2-4760049adb94
Record created2016-06-03
Record modified2016-06-03
Bookmark and share
  • Share this page with Facebook (Opens in a new window)
  • Share this page with Twitter (Opens in a new window)
  • Share this page with Google+ (Opens in a new window)
  • Share this page with Delicious (Opens in a new window)